Design Guide for Drilled Piers - Supplemental Spreadsheets
IMPORTANT: BY ACCESSING AND USING THIS SPREADSHEET, YOU INDICATE YOUR ACCEPTANCE OF THE TERMS OF THIS LICENSE AGREEMENT. IF YOU DO NOT AGREE TO THE TERMS OF THIS AGREEMENT, DO NOT USE THIS SPREADSHEET AND DELETE IT FROM YOUR COMPUTER. Concrete Reinforcing Steel Institute (“CRSI”) grants you (“Licensee”) the right to use this spreadsheet on a single computer only. The material contained herein is the property of Concrete Reinforcing Steel Institute and is protected by United States and international copyright laws. The copyright laws protect the material contained in this spreadsheet as if it were printed in a book. Licensee is not permitted to remove any copyright notices contained herein. No part of the spreadsheet may be reproduced, translated, reduced to any other electronic medium or machine-readable form, or re-transmitted in whole or in part. You acknowledge that you have read this Agreement and understand it and that, by using the spreadsheet, you agree to be bound by its terms and conditions. You also agree that this is the complete and exclusive statement of the agreement between yourself and CRSI relative to the subject matter of this Agreement, which supersedes any proposal or prior agreement oral or written.
The Design Guide for Drilled Piers references two supplemental spreadsheets that are available for downloading. Each are briefly described.
APPENDIX A: General building and bridge solutions for 100k lateral load at pier head.
APPENDIX B: Design axial strength and bending moments for round spiral and round tied drilled piers.
Disclaimer
These spreadsheets are intended for the use of professionals competent to evaluate the significance and limitations of its contents and who will accept responsibility for the application of the material they contain. The Concrete Reinforcing Steel Institute reports the foregoing material as a matter of information and, therefore, disclaims any and all responsibility for application of the stated principles or for the accuracy of the sources other than material developed by the Institute.